Diagnostics and repair
An experienced technician checks the appliance before suggesting any work. OEM parts can be ordered, matched to your exact model.
Display reference
Pick the appliance, then type the code as shown. What it means depends on the model.
F3 is listed by Frigidaire as “Communication Error” for range ovens. No cause is printed. F20 and F26 carry the same name in the guide and have their own pages. Press OFF, reset the power, set the clock and retry; arrange service if it returns.
Read the F3 checks9 researched oven codes. Codes differ from model to model; your manual has the final word.
One manual prints iC0 and the other EC0, which breaks the usual pattern, and the reset step differs: 5 minutes in a manual, 3 minutes in an article. ER, UO and UF appear in neither table nor any article.
E68, E5B and E10 are not in that manual. One manual is a thin base, so we describe the three printed codes and say nothing about older dryer generations.
The documents differ on details: the HI tone repeats every 60 seconds in one article and every 10 seconds in a manual. We name those conflicts on the pages rather than pick one. DF is not mentioned anywhere we looked.

See what the manuals cover and which codes they leave unexplained.

9 codes researched, each with its sources and model limits.

11 codes researched, each with its sources and model limits.

See what the manuals cover and which codes they leave unexplained.

See what the manuals cover and which codes they leave unexplained.

8 codes researched, each with its sources and model limits.

5 codes researched, each with its sources and model limits.

5 codes researched, each with its sources and model limits.
Write down the appliance, the model and the full code together.
A code tells you what to check first. It does not tell you which part to replace.
An experienced technician checks the appliance before suggesting any work. OEM parts can be ordered, matched to your exact model.
If Frigidaire’s warranty covers the problem, Frigidaire does that repair. Work we do is covered by our own workmanship warranty.
Codes that a Frigidaire document explains, and older ones people still search for. Oven, dishwasher, washer, refrigerator and dryer each have a hub. Where Frigidaire gives no meaning, the page says that plainly.
Current Frigidaire front-load washers show AL codes, and the older E-series is not in Frigidaire's own documents. We group those E-codes on one shared page instead of guessing at each.
No. E4 means out of balance on a top-load washer and a humidity sensor on a dryer. Read the page for your appliance type, and check the model against what the page covers.
Take a picture of the entire display first, then read the model off the nameplate. A look-alike code on another product is no guide. Send both when you book a technician.
They are separate. The CPSC recall 26-333 concerns delayed ignition of the bake burner on certain gas ranges. Check your model and serial number on the CPSC notice if you own one.
Code / problem / part / repair
Frigidaire sorts refrigerator leaks by where the water shows up: outside the unit (back connections and the water valve), inside (the water filter), or at the dispenser (frost in the chute, or air in the line). A door left open can also ice up the evaporator and leak from the bottom. Find the spot first, and book if the source isn’t one of these.
Book a diagnostic for your model, done at your home.
Office addresses and the entry details to have ready.