What it means
i50 means a problem has been detected with the drain or wash motor. The manual says to press Cancel or switch off at the breaker for 5 minutes, which should clear the code so you can restart. If i50 returns, book a technician.
Frigidaire dishwasher i50 / Motor
i50 means a problem has been detected with the drain or wash motor. The manual says to press Cancel or switch off at the breaker for 5 minutes, which should clear the code so you can restart. If i50 returns, book a technician.
Also shown as i50
i50 means a problem has been detected with the drain or wash motor. The manual says to press Cancel or switch off at the breaker for 5 minutes, which should clear the code so you can restart. If i50 returns, book a technician.
Press Cancel, or switch the dishwasher off at the breaker and leave it off for 5 minutes.
i50 comes back after the reset.
Your checklist / kept on this device

Press Cancel, or switch the dishwasher off at the breaker and leave it off for 5 minutes. The manual gives this as the step for every error code. That should clear the code and let you restart.

Run a cycle and watch for i50.

The manual lists no other owner steps and points to service.
Tell us the model and what you have already checked, and start the request right here.
Book a visit

Simplified schematic; real layouts differ by model. Tap an outlined part for its photo and the check that goes with it.

Component reference
The drain pump moves used water out of the dishwasher.
Read the definitionThe row says drain or wash motor and doesn't separate them. Testing is a service job.
Read the supporting manualThe manual attaches filter and drain-line checks to the clog codes, not to i50.
Read the supporting manualManufacturer document
Frigidaire / Electrolux
September 2020 / PDF p.9 (Error Code table)
Manufacturer document
Frigidaire / Electrolux
No date printed / PDF p.10, section 4.5 Error Codes
This code is from the i-code table in the 2020 Use & Care guide. The newer dishwasher manual prints the same table with an E prefix, so read the row in the manual that came with your dishwasher. On the newer display the same row reads E50.
The manual says a problem has been detected with the drain or wash motor. It doesn't say which of the two, or what is wrong.
The manual lists no filter step for i50; those checks belong to i20 and i40. The one owner step is the reset.
The newer manual prints the row as E50 with the same meaning. Check the table that matches your dishwasher.
Book a technician. The manual gives no further owner steps.
Code / problem / part / repair
Most dishwasher sounds are part of a normal cycle. Frigidaire’s noise guide lists hissing from the water valve, humming from the wash and drain pumps, and a clunk when the detergent cup opens. A knock or bang usually means something is hitting a spray arm.
The drain pump moves used water out of the dishwasher. Frigidaire’s noise guide describes its hum as steady at first, then changing as the last water goes out. For i20 Frigidaire checks the hose, the disposer plug and the filters; i50 covers a problem with the drain or wash motor.
Book a diagnostic for your model, done at your home.
Office addresses and the entry details to have ready.