What it means
F10 on a Frigidaire wall or standard oven is a Thermal Runaway alert: the control senses more heat than normal and is protecting the appliance. Switch it off, wait until it is cold, and only then think about cooking again.
Frigidaire oven F10 / Heating
F10 on a Frigidaire wall or standard oven is a Thermal Runaway alert: the control senses more heat than normal and is protecting the appliance. Switch it off, wait until it is cold, and only then think about cooking again.
Also shown as F10
F10 on a Frigidaire wall or standard oven is a Thermal Runaway alert: the control senses more heat than normal and is protecting the appliance. Switch it off, wait until it is cold, and only then think about cooking again.
Stop the function and keep the door closed while the cavity cools.
F10 returns once the oven has cooled and been reset.
Your checklist / kept on this device

Stop the function and keep the door closed while the cavity cools.

Frigidaire wants it cool before it is used again.

On a Stone-Baked Pizza model, the rack and Pizza Shield should both sit in position 7 (some models differ). Fix that, reset, and restart the preheat.

Half a minute without power, by pulling the plug or opening the breaker, which also affects anything else on that circuit.

A returning F10 means the oven stays off until a technician has seen it.
Tell us the model and what you have already checked, and start the request right here.
Book a visit
Simplified schematic; real layouts differ by model. Tap an outlined part for its photo and the check that goes with it.

Component reference
The oven electronic control is the electronics behind the keys and display on a Frigidaire range.
Read the definitionFrigidaire's guide calls it Thermal Runaway. On standard range ovens and wall ovens the oven is detecting higher-than-normal temperatures, which it treats as a safety matter.
Read the supporting manualYes. The guide says F10 on those models can follow from the Pizza Shield sitting on the wrong rack, so rack position 7 is the check.
Read the supporting manualFrigidaire says to ask for support if it persists. Our advice is to stop baking and book a technician.
Read the supporting manualManufacturer document
Frigidaire / Owner Center knowledge base
Owner Center article, cached 10.11.2026 (no edition date printed) / Article text
Manufacturer document
Frigidaire / Electrolux
No edition date printed / PDF p.17 (Troubleshooting)
Owner Center oven guide for wall ovens, standard range ovens and Stone-Baked Pizza models; manual A30923902 backs the general F and E step.
Yes, a little. It signals excess heat, so do not carry on baking.
Only once the oven has cooled. A second F10 means stop.
There is one, built on the electric-range article.
The model, and whether a pizza stone sat inside at the time.
Code / problem / part / repair
F30 is the entry Frigidaire lists as “Open Probe” for range ovens. The sources give no cause or part beyond the name. Reset the power, set the clock and retry Bake or Broil, then arrange service if F30 repeats.
A flashing 12:00 on a Frigidaire range means the control lost power and forgot the time. The manuals say the clock must be set before the oven will run, so set it first. Then check the 12/24-hour mode, the minute timer, a dash on the display and Delay Start. If the clock keeps resetting without a power cut, book a technician.
The oven electronic control is the electronics behind the keys and display on a Frigidaire range. When it detects a problem it beeps and shows an F or E code. The manual's steps are to press OFF to clear it, try Bake or Broil, and if the code repeats, cut power for 5 minutes, repower and set the clock.
Book a diagnostic for your model, done at your home.
Office addresses and the entry details to have ready.