Manual evidence
The A117867311 and 117825980A tables list i-codes or E-codes and nothing starting with U. The Owner Center dishwasher articles do not mention UO. The common footnote is the only guidance: Cancel or 5 minutes without power.
Frigidaire dishwasher UO / Dishwasher
UO is not in Frigidaire's published dishwasher code tables, so we have no meaning to give. Frigidaire's footnote for any code is Cancel or a 5-minute breaker-off. If UO returns, book a technician.
Frigidaire's dishwasher tables say pressing Cancel can clear an error code. Close the door fully first, because a door that is not latched can itself trigger a message.
If Cancel does not help, turn the dishwasher off at the breaker for 5 minutes, per the footnote under both Frigidaire error tables, then power it back up and start a cycle.

UO reappears once Cancel and the 5-minute power-off are done, or the dishwasher refuses to run a cycle.
Source 1
Frigidaire / Electrolux / September 2020 / PDF p.9 (error code table and footnote)
Source 2
Frigidaire / Electrolux / Current edition (28 pages, no date printed) / PDF p.10 (error code table and footnote)
Source 3
Frigidaire / Owner Center knowledge base / Owner Center article, cached 10.11.2026 (no edition date printed) / Article text
No source says so. HO is a Frigidaire message for heater-on mode; the letters differ and UO has no entry. Check both letters on the display.
We cannot confirm it. Frigidaire's unlevel-related entry is the i30 or E30 leak alarm. UO is not tied to leveling, so do not adjust feet on the strength of it.
The sources are silent on that. Write down when it shows, such as at power-up or mid-cycle; a pattern helps a technician.
Run the Cancel and breaker-off steps once. If it still will not run, book a diagnostic and mention that you tried them.