Before work starts
The technician quotes the work to you at the visit, after looking at the appliance, and nothing is done until you say yes.
Independent appliance repair
We repair Frigidaire refrigerators that run warm, leak, build up frost, make noise or stop making ice and water. Say which section is warm and whether any alarm shows, then book a visit.


Frigidaire sorts refrigerator leaks by where the water shows up: outside the unit (back connections and the water valve), inside (the water filter), or at the dispenser (frost in the chute, or air in the line). A door left open can also ice up the evaporator and leak from the bottom. Find the spot first, and book if the source isn’t one of these.

Frigidaire’s articles don’t describe an ice maker overflow as such, so we can’t name a cause from them. They do cover the nearby problems: ice jammed between the ice maker and the bin, a frozen auger, and frost or melt in the ice chute. Work through those, and turn the ice maker off if you need it to stop while you book.

Frigidaire’s fix order for a dead water dispenser starts with the display lock: hold the lock key for 3 seconds. Then check the water filter (seated, not cracked, not overdue), the supply to a new install, and a recent power cut. After a new filter or install, prime and purge the system before you judge the dispenser.

Frigidaire publishes a noise guide for its refrigerators that lists the sounds it counts as normal: gurgling refrigerant, fans blowing, hissing during defrost, ice falling, clicking from the ice chute solenoid, a high-pitched compressor hum and the water valve buzzing. Match your sound to that list, and check that the cabinet is level, before booking.

Frigidaire explains frost as warm and cold air meeting below 32°F, and lists four causes: a door or gasket that doesn’t seal, an ice chute flap that doesn’t close, a setting colder than the recommended 0°F, and food blocking the air paths. Check those four. Unplug before you remove frost.

On Frigidaire refrigerators, a dark light often has a simple reason: Sabbath mode turns the lights off, the door was left open for 5 minutes on some models, the light switch is stuck, or the LED bulb needs replacing. The manual calls for a 5-watt or lower AC LED bulb and says to unplug first.

Unplug it, then book a technician. Frigidaire’s own articles cover food odors only and have no guidance on a burning or electrical smell, so we won’t offer a diagnosis. A refrigerator runs around the clock, and a hot or burning smell is a reason to cut power before anything else.

Frigidaire’s fix order for a warm refrigerator: power, a recent outage, the temperature setting (37°F fridge, 0°F freezer), blocked vents and the door seal. For a too-cold refrigerator the same article points to the setting and to food blocking the vents. An HI alarm shows when the freezer reaches 26°F or the fridge reaches 55°F.

Frigidaire’s article for a warm freezer starts with installation and power, then the setting (0°F), a recent outage, where the unit stands, the door seal, frost and how full the freezer is. Compressor hum, fans and gurgling mean the unit is trying to cool. If it has run for 24 hours and still isn’t cold, schedule service.

Frigidaire’s order for an ice maker that makes no ice: how long the unit has been plugged in (24 hours to stabilize), a recent outage, the display lock, water to the unit, the filter, and ice or a frozen auger in the bin. On a new install, the ice maker needs the water system primed first, as air in the lines can cause 2 or 3 empty cycles.
We have not researched code meanings for this appliance yet. Use its manual and add a photo of the display to your request.
See the research statusWe don’t list parts for this appliance up front. The technician names any part after the diagnostic and matches it to your exact model before anything is replaced.

We have no illustrated entry for this part yet. Follow the system named in the explanation and the manual cited for your model; a code by itself never tells you what to replace.
Explore the researched partsThree short stages.
Plain, and kept short.

Pick the appliance, describe the problem and add the model number if you have it. The booking form is open 24/7.

The technician checks the range, fridge or washer, explains what failed and quotes the repair before starting.

Parts are fitted, the work is tested, and you see the appliance running before the technician leaves.
HI, PF, Door Ajar, Sb and DI SP are the alarms Frigidaire lists. Write down which one is showing and when it began.
Frigidaire’s steps: power at the outlet, doors closing fully, vents clear and a good door seal. A dollar bill should resist a tug when shut in the door.
Frigidaire says a unit needs about 24 hours to settle in temperature after being reset or plugged in.
For ice or water trouble, the filter must sit correctly and not be frozen or cracked. Frigidaire suggests changing it every 6 months and priming a new one.
Pull items away from the vents and clear the floor around the unit.
Book a visit if the refrigerator is still warm 24 hours after the basic checks.
Book a visit for water on the floor you can’t trace to a loose line, or for ice and water that stay off after the filter and lock checks.
Unplug the unit and book at once for a burning smell.
Leave sealed-system and electrical work to the technician.
Arrange a diagnosticThe technician quotes the work to you at the visit, after looking at the appliance, and nothing is done until you say yes.
If Frigidaire’s warranty covers the problem, Frigidaire does that repair. Work we do is covered by our own workmanship warranty.
HI is the high-temperature alarm: a section went above its limit, often from a door left open or not sealing. Close the door and let it recover. If HI keeps coming back, book a technician.
Frigidaire points to a locked display, a missing water supply, a misfitted or frozen filter, a frozen auger or ice jammed in the bin. Check those. If ice still doesn’t come, book a visit.
Frigidaire suggests 37 °F in the refrigerator and 0 °F in the freezer, with 33–47 °F and -6 to 6 °F as the acceptable ranges. A unit outside those after 24 hours needs a look.
If your unit is under Frigidaire’s warranty, Frigidaire handles that repair. For anything else, book a visit with us; the price is agreed before work begins.
Frigidaire’s article lists them as codes that need service but gives no meaning for them. Book a technician and tell us the code and the model.
Code / problem / part / repair
Frigidaire sorts refrigerator leaks by where the water shows up: outside the unit (back connections and the water valve), inside (the water filter), or at the dispenser (frost in the chute, or air in the line). A door left open can also ice up the evaporator and leak from the bottom. Find the spot first, and book if the source isn’t one of these.
Book a diagnostic for your model, done at your home.
Office addresses and the entry details to have ready.