What it means
Sb on a Frigidaire freezer's display means Sabbath mode is on. Sb is an observance setting that someone turned on. Holding minus and TEMP F/C for five seconds exits it.
Frigidaire freezer Sb / Mode, not a failure
Sb on a Frigidaire freezer's display means Sabbath mode is on. Sb is an observance setting that someone turned on. Holding minus and TEMP F/C for five seconds exits it.
Also shown as Sb
Sb on a Frigidaire freezer's display means Sabbath mode is on. Sb is an observance setting that someone turned on. Holding minus and TEMP F/C for five seconds exits it.
Press the minus (-) button and TEMP F/C together for 5 seconds.
Sb will not clear with the two-button hold.
Your checklist / kept on this device

Press the minus (-) button and TEMP F/C together for 5 seconds.

The display shows its icons again once Sabbath mode ends.

The ice maker stops while Sabbath mode is on, so ice production resumes only after you exit.

If someone chose Sb on purpose, leave it alone. If not, confirm the set temperature after exiting.
Tell us the model and what you have already checked, and start the request right here.
Book a visit
Simplified schematic; real layouts differ by model. Tap an outlined part for its photo and the check that goes with it.
The guide says Sb on the control display shows the unit is in Sabbath mode, which switches off parts of the controls for Sabbath and holiday observance.
Read the supporting manualThe HIGH TEMP alarm remains on for health reasons. It triggers after the cabinet spends 20 minutes out of range and silences itself 10 minutes later.
Read the supporting manualNo. Power returning does not end it; only the display buttons do.
Read the supporting manualManufacturer document
Frigidaire / Electrolux
February 2021 / PDF p.17 (Sabbath Mode), p.26 (Troubleshooting)
Manufacturer document
Frigidaire / Electrolux
February 2021 / PDF p.18 (To exit Sabbath Mode)
From the upright freezer guide A16366303 (February 2021), which says several models carry a Sabbath feature.
No. It is an observance mode that is set on purpose.
While Sabbath mode is on, the lights and the display stay off except for the exit combination.
Per the guide, ice production halts while it is on.
Repeat the two-button hold with a firm, steady press. If it still will not exit, a visit with us is the next move.
Code / problem / part / repair
A red HIGH TEMP light with an alarm on a Frigidaire freezer means the cabinet rose above its safe range. Shut the door, inspect the food, and press HIGH TEMP to reset. A repeat means booking a technician.
Frigidaire's article runs through install and power first, then the setting, a recent outage, the location, the door seal, frost and overloading. The suggested freezer setting is 0 F. If the unit has run for 24 hours and is still not cold, schedule service.
Book a diagnostic for your model, done at your home.
Office addresses and the entry details to have ready.