What it means
A flashing green Power On light on a Frigidaire freezer is normal right after you plug it in. It flashes until the freezer reaches the selected temperature. Wait it out.
Frigidaire freezer Green Power On light flashing / Mode, not a failure
A flashing green Power On light on a Frigidaire freezer is normal right after you plug it in. It flashes until the freezer reaches the selected temperature. Wait it out.
Also shown as Green Power On light flashing
A flashing green Power On light on a Frigidaire freezer is normal right after you plug it in. It flashes until the freezer reaches the selected temperature. Wait it out.
Frigidaire says to run the freezer with the door closed for at least 8 hours before loading food.
The green light keeps flashing days after start-up.
Your checklist / kept on this device

Frigidaire says to run the freezer with the door closed for at least 8 hours before loading food.

Each opening slows the cool-down.

Leave it on Recommended unless you have a reason to change it.

If it keeps flashing for days, tell us the model number.
Tell us the model and what you have already checked, and start the request right here.
Book a visit
Simplified schematic; real layouts differ by model. Tap an outlined part for its photo and the check that goes with it.
The quick guide says it flashes continuously when the freezer is first plugged in, until the unit reaches the selected temperature.
Read the supporting manualThe guide gives no time for the light. It does say the freezer should run 8 hours with the door closed before you load food.
Read the supporting manualNot necessarily. For a warmer freezer than you like, the guide says to choose a colder setting and allow 24 hours.
Read the supporting manualManufacturer document
Frigidaire / Electrolux
No edition date printed (file dated March 2025) / PDF p.1 (You're in control, FAQs)
Frigidaire freezers that project a green LED Power On light, quick guide A29320902.
No. It reports that the freezer is still cooling toward its setting.
The guide describes it at first plug-in only. After an outage the freezer cools down again, so flashing is plausible, but the guide does not say.
The cabinet may not be reaching its setting. Inspect the door seal, the setting and the contents, then book a visit.
No. Frigidaire says to wait at least 8 hours first.
Code / problem / part / repair
A red HIGH TEMP light with an alarm on a Frigidaire freezer means the cabinet rose above its safe range. Shut the door, inspect the food, and press HIGH TEMP to reset. A repeat means booking a technician.
Frigidaire's article runs through install and power first, then the setting, a recent outage, the location, the door seal, frost and overloading. The suggested freezer setting is 0 F. If the unit has run for 24 hours and is still not cold, schedule service.
Book a diagnostic for your model, done at your home.
Office addresses and the entry details to have ready.