Manual evidence
No entry for UF exists in the A117867311 table, the 117825980A table or the dishwasher knowledge-base articles we read. The tables' footnote about Cancel and a 5-minute power-off is the only general instruction.
Frigidaire dishwasher UF / Dishwasher
Frigidaire does not define UF for dishwashers. It is not in either printed code table. Use the manual's footnote steps, Cancel or a 5-minute breaker-off, and book a technician if UF comes back.
Frigidaire's dishwasher tables say pressing Cancel can clear an error code. Close the door fully first, because a door that is not latched can itself trigger a message.
If Cancel does not help, turn the dishwasher off at the breaker for 5 minutes, per the footnote under both Frigidaire error tables, then power it back up and start a cycle.

UF reappears once Cancel and the 5-minute power-off are done, or the dishwasher refuses to run a cycle.
Source 1
Frigidaire / Electrolux / September 2020 / PDF p.9 (error code table and footnote)
Source 2
Frigidaire / Electrolux / Current edition (28 pages, no date printed) / PDF p.10 (error code table and footnote)
Source 3
Frigidaire / Owner Center knowledge base / Owner Center article, cached 10.11.2026 (no edition date printed) / Article text
We cannot say. The filter and drain codes Frigidaire explains are i20, i40 and iF0 (E20, E40, EF0 on newer models). UF is not among them.
We cannot know that from here. If your display shows a lowercase i or an E, the documented codes apply; compare the characters carefully.
It is harmless and Frigidaire recommends cleaning them for drain problems. Just do not treat a clean filter as proof that UF is fixed.
If it returns after one Cancel and a 5-minute breaker-off, or if the dishwasher stops filling, draining or heating, a diagnostic is the next step.