Frigidaire dishwasher i20 / Drain

Frigidaire dishwasher
error i20

Dishwasher / display referencei20

i20 means clogged filters or a restricted drain line were detected, and Frigidaire's article adds that the unit didn't drain completely. Clean both filters and the sump, check the drain hose, then reset the dishwasher.

Also shown as i20

Last reviewed

Dishwasher / display referencei20
Meaning
i20 means clogged filters or a restricted drain line were detected, and Frigidaire's article adds that the unit didn't drain completely. Clean both filters and the sump, check the drain hose, then reset the dishwasher.
Who handles it
Owner checks first, then a technician
Related codes
Source
Dishwasher Use & Care, A117867311

What Frigidaire dishwasher i20 means.

What it means

i20 means clogged filters or a restricted drain line were detected, and Frigidaire's article adds that the unit didn't drain completely. Clean both filters and the sump, check the drain hose, then reset the dishwasher.

What you can safely check

Check and clean both filters and the sump area, where the manual says to start.

When to call a technician

i20 returns after the filters, the hose and the reset have been checked.

Your checklist / kept on this device

Safe checks, in order.

0 of 4 checks done
  1. Frigidaire dishwasher i20: Row of small touch buttons and one glowing light along the top edge of a stainless dishwasher door, seen at a low angle.
    Illustration. Follow your model’s instructions.
    Before you begin

    Clean both filters and the sump

    Check and clean both filters and the sump area, where the manual says to start.

  2. Open dishwasher tub with the lower rack removed and a shallow pool of water around the cylindrical filter.
    Illustration. Follow your model’s instructions.
    Check 2

    Check the drain hose

    Look for a pinched or blocked drain hose. Frigidaire's i20 article also asks that the hose rise at least 32 inches from the floor.

  3. Hand lifting a gray dishwasher spray arm above its hub in an empty tub with the lower rack removed
    Illustration. Follow your model’s instructions.
    Check 3

    Check the disposer knockout

    If the drain line connects to a garbage disposer, make sure the knockout plug has been removed.

  4. Technician in a dark jacket seen from behind holding a tablet with an empty checklist, a range in the background.
    Illustration. Follow your model’s instructions.
    Check 4

    Reset it

    The manual says Cancel, or power off at the breaker for 5 minutes. The i20 article says Cancel, the breaker, or unplugging for 3 minutes. Use the time your manual gives.

Still showing i20?

Tell us the model and what you have already checked, and start the request right here.

Book a visit

The water-out path.

Conceptual dishwasher sectionFiltersSumpDrain pumpDrain hoseSink connection12345
  1. 2Sump
  2. 4Drain hose
  3. 5Sink connection

Simplified schematic; real layouts differ by model. Tap an outlined part for its photo and the check that goes with it.

Parts behind the message.

Cylindrical fine filter and flat mesh coarse filter with bits of food soil caught in the mesh on a walnut bench.

Component reference

Dishwasher filter and glass trap

The filter system at the bottom of the dishwasher tub catches food soil so it doesn’t clog the drain.

Read the definition
Dishwasher drain pump with white motor housing, gray impeller cover, outlet spout and electrical connector on a bench.

Component reference

Dishwasher drain pump

The drain pump moves used water out of the dishwasher.

Read the definition

A little more context.

Is i20 always a clog?

The table says clogged filters or a restricted drain line. It doesn't list other causes, so work through those two first.

Read the supporting manual

Which reset time should I use?

The manual and Frigidaire's i20 article give different times. Both are official, so follow the manual for your model.

Read the supporting manual

The manual behind the message.

Manufacturer document

Dishwasher Use & Care, A117867311

Frigidaire / Electrolux

September 2020 / PDF p.9 (Error Code table)

Manufacturer document

Dishwasher Error Code i20 (KB 1830367)

Frigidaire / Owner Center knowledge base

Owner Center article, cached 10.11.2026 (no edition date printed) / Article text

Manufacturer document

Dishwasher Error Codes and Alarms Guide (KB 1829620)

Frigidaire / Owner Center knowledge base

Owner Center article, cached 10.11.2026 (no edition date printed) / Article text

Manufacturer document

User Manual, Dishwasher, 117825980A

Frigidaire / Electrolux

No date printed / PDF p.10, section 4.5 Error Codes

This code is from the i-code table in the 2020 Use & Care guide. The newer dishwasher manual prints the same table with an E prefix, so read the row in the manual that came with your dishwasher. In that table i20, i40 and iF0 share a row, and the newer manual prints it as E20, E40 and EF0. The reset time differs between the manual and the article, so your manual decides.

Here to help

Good questions.
Clear answers.

Talk to our team
Are i20, i40 and iF0 the same?

The manual prints them in a single row with one meaning. Frigidaire's separate articles describe i20 as not draining completely and i40 as a clogged filter or sump.

How long do I leave the power off?

The manual says 5 minutes at the breaker. The i20 article says 3 minutes and lists Cancel or unplugging as alternatives. Use the time in your manual.

What is the knockout plug?

When the drain line connects to a garbage disposer, a plug in the disposer inlet has to be removed first. The manual lists it as a drain check.

What if the filters are clean?

Check the hose and the disposer connection next. If i20 still shows, the manual says to arrange service.

Let’s take care of it.

The range is the heart
of the kitchen. Let’s fix it.