What it means
01-24 on a Frigidaire dishwasher is not an error. Frigidaire's article says the Delay option is on, and the cycle begins when the displayed time reaches 0. To cancel the delay, press or hold Cancel.
Frigidaire dishwasher 01-24 / Mode, not a failure
01-24 on a Frigidaire dishwasher is not an error. Frigidaire's article says the Delay option is on, and the cycle begins when the displayed time reaches 0. To cancel the delay, press or hold Cancel.
Also shown as 01-24
01-24 on a Frigidaire dishwasher is not an error. Frigidaire's article says the Delay option is on, and the cycle begins when the displayed time reaches 0. To cancel the delay, press or hold Cancel.
01-24 comes with a countdown.
No normal cycle starts even after Delay is canceled.
Your checklist / kept on this device

01-24 comes with a countdown. The cycle waits until the time shown reaches 0.

This cancels the delayed start, per Frigidaire's article.

A second press drops the chosen cycle and runs a drain.

Pressing a third time ends the drain and powers the unit down. Then start the cycle you want.
Tell us the model and what you have already checked, and start the request right here.
Book a visit
Simplified schematic; real layouts differ by model. Tap an outlined part for its photo and the check that goes with it.
Frigidaire's article says the delay option has been enabled, and the cycle starts once the countdown reaches 0. Until then the dishwasher looks idle.
Read the supporting manualPress or hold Cancel. The second press scraps the chosen cycle and drains the tub; the third halts that drain and powers the unit down.
Read the supporting manualWith the delay canceled and still no normal cycle, look beyond the timer; a visit with us would cover that.
Read the supporting manualManufacturer document
Frigidaire / Owner Center knowledge base
Owner Center article, cached 10.11.2026 (no edition date printed) / Article text
Frigidaire dishwashers with a Delay option, per Owner Center article 1830334. The article does not list models.
No. It shows that the delay timer is running, so the cycle is simply waiting.
If 01-24 is showing, Delay is probably set. Cancel it and start the cycle again.
Frigidaire says that second press triggers a drain for the cycle you picked.
Check that nobody presses Delay before each load. If it returns on its own, note when it happens and book a visit.
Code / problem / part / repair
i20 means clogged filters or a restricted drain line were detected, and Frigidaire's article adds that the unit didn't drain completely. Clean both filters and the sump, check the drain hose, then reset the dishwasher.
Most dishwasher sounds are part of a normal cycle. Frigidaire’s noise guide lists hissing from the water valve, humming from the wash and drain pumps, and a clunk when the detergent cup opens. A knock or bang usually means something is hitting a spray arm.
Book a diagnostic for your model, done at your home.
Office addresses and the entry details to have ready.