What it means
i60 means a problem has been detected with the water heating system. The manual gives one owner step, the reset: Cancel, or power off at the breaker for 5 minutes. If i60 stays, service will be needed.
Frigidaire dishwasher i60 / Heating
i60 means a problem has been detected with the water heating system. The manual gives one owner step, the reset: Cancel, or power off at the breaker for 5 minutes. If i60 stays, service will be needed.
Also shown as i60
i60 means a problem has been detected with the water heating system. The manual gives one owner step, the reset: Cancel, or power off at the breaker for 5 minutes. If i60 stays, service will be needed.
Press Cancel, or switch the dishwasher off at the breaker and leave it off for 5 minutes.
i60 comes back after the reset.
Your checklist / kept on this device

Press Cancel, or switch the dishwasher off at the breaker and leave it off for 5 minutes. The manual gives this as the step for every error code.

Start a cycle and watch whether i60 appears again.

The manual says that if the reset doesn't resolve the problem, service will need to be called.
Tell us the model and what you have already checked, and start the request right here.
Book a visitSimplified schematic; real layouts differ by model. Tap an outlined part for its photo and the check that goes with it.

Component reference
The heating element warms the water and helps dry the load.
Read the definitionThe manual names the water heating system, not a part. A technician has to find which part is involved.
Read the supporting manualIt is the one step the manual gives, and it costs nothing to try before you call.
Read the supporting manualManufacturer document
Frigidaire / Electrolux
September 2020 / PDF p.9 (Error Code table)
Manufacturer document
Frigidaire / Electrolux
No date printed / PDF p.10, section 4.5 Error Codes
This code is from the i-code table in the 2020 Use & Care guide. The newer dishwasher manual prints the same table with an E prefix, so read the row in the manual that came with your dishwasher. On the newer display the same row reads E60.
The manual says a problem has been detected with the water heating system. No heater or sensor is named.
No. HO or Hd is a normal mode while the unit heats the water. i60 is listed in the code table as a detected problem.
The manual lists only the reset. There are no filter, hose or supply checks for i60.
The newer manual prints the same row as E60. Read the table in the manual that matches your dishwasher.
Code / problem / part / repair
iC0 means a problem has been detected with the electronic control system. The manual's only owner step is the reset: Cancel, or power off at the breaker for 5 minutes. If iC0 returns, book a technician.
Most dishwasher sounds are part of a normal cycle. Frigidaire’s noise guide lists hissing from the water valve, humming from the wash and drain pumps, and a clunk when the detergent cup opens. A knock or bang usually means something is hitting a spray arm.
The heating element warms the water and helps dry the load. Frigidaire’s manual lists it among the dishwasher’s parts and warns that it stays hot, so let it cool before cleaning the tub. i60 means a problem with water heating, and HO or Hd means Heat Delay or Heater On mode, a heating step rather than a problem.
Book a diagnostic for your model, done at your home.
Office addresses and the entry details to have ready.