What it means
Frigidaire's knob-operated induction cooktop prints HE for Hot Element: the surface has not cooled enough to touch safely. It is a warning, not an error. Stay off the glass until the indicator light is out.
Frigidaire cooktop HE / Mode, not a failure
Frigidaire's knob-operated induction cooktop prints HE for Hot Element: the surface has not cooled enough to touch safely. It is a warning, not an error. Stay off the glass until the indicator light is out.
Also shown as HE
Frigidaire's knob-operated induction cooktop prints HE for Hot Element: the surface has not cooled enough to touch safely. It is a warning, not an error. Stay off the glass until the indicator light is out.
The manual's caution says there is a risk of burns when HE appears.
HE stays on after the cooktop has been off for hours, or shows alongside C0.
Your checklist / kept on this device

The manual's caution says there is a risk of burns when HE appears.

Our general advice: pans left on the glass keep it hot longer.

Frigidaire says to wait until it is off before touching the surface.

The manual allows turning the zone back on while HE shows.
Tell us the model and what you have already checked, and start the request right here.
Book a visitSimplified schematic; real layouts differ by model. Tap an outlined part for its photo and the check that goes with it.
The manual lists "HE Hot Element" as a display message. It appears while the surface has not cooled enough to touch safely.
Read the supporting manualYes. The manual says the cooking zone can be turned on again for use while the message is up.
Read the supporting manualOn the first two zones a live error replaces the heat warning, so a C0 on the left side would take HE's place.
Read the supporting manualManufacturer document
Frigidaire / Electrolux
July 2024 / PDF p.6 (4.1 Other display messages), p.7 (caution under 4.2)
Manufacturer document
Frigidaire / Electrolux
July 2024 / PDF p.9 (6.2 Error Codes Display Message)
Taken from A01704805/A (July 2024), the guide for the knob-operated Professional cooktop.
No. It is the hot-surface warning of the knob-control Professional cooktop.
The manual gives no time. It goes out when the glass has cooled, and that varies with the pan and the cooking time.
No. A heating zone shows a power level. HE shows leftover heat in the glass.
If it stays when the cooktop has been off for hours, or an error appears beside it, we should check the cooktop.
Code / problem / part / repair
C0 on the Professional induction cooktop from Frigidaire is an error that appears in zone 1 or 2, on the left. The manual offers no owner fix beyond setting the knobs to OFF. If C0 stays or the knobs stay dead, book a technician.
An uneven flame usually means clogged ports or a cap that is not seated. An orange flame can come from dust in the gas line, which clears in a few minutes, or from a wrong L.P. conversion. A flame set too high points to the knob, the cap or the L.P. kit.
Book a diagnostic for your model, done at your home.
Office addresses and the entry details to have ready.