What it means
C0 on the Professional induction cooktop from Frigidaire is an error that appears in zone 1 or 2, on the left. The manual offers no owner fix beyond setting the knobs to OFF. If C0 stays or the knobs stay dead, book a technician.
Frigidaire cooktop C0 / Boards and communication
C0 on the Professional induction cooktop from Frigidaire is an error that appears in zone 1 or 2, on the left. The manual offers no owner fix beyond setting the knobs to OFF. If C0 stays or the knobs stay dead, book a technician.
Also shown as C0
C0 on the Professional induction cooktop from Frigidaire is an error that appears in zone 1 or 2, on the left. The manual offers no owner fix beyond setting the knobs to OFF. If C0 stays or the knobs stay dead, book a technician.
This is the manual's reset for the surface controls, so do it first.
C0 comes back after the knobs were set to OFF.
Your checklist / kept on this device

This is the manual's reset for the surface controls, so do it first.

If HE is lit, keep hands off the glass. The manual warns of burns.

Our own general advice: spills or objects near controls can confuse a cooktop. This is not from the manual.
If the knob responds and C0 stays gone, keep watching. If it does not respond, stop and call us.
Tell us the model and what you have already checked, and start the request right here.
Book a visitSimplified schematic; real layouts differ by model. Tap an outlined part for its photo and the check that goes with it.
The manual's section on error codes says an error in any zone shows C0 in zones 1 or 2 on the left side of the cooktop. It does not name a cause.
Read the supporting manualIf the error occurs while one of the first two zones is active and hot enough to show HE, the error is what the display shows, and the hot-element message gives way.
Read the supporting manualFrigidaire's note says knobs that still do not work after a reset, with C, Er or -- on the display, mean service is needed.
Read the supporting manualManufacturer document
Frigidaire / Electrolux
July 2024 / PDF p.9 (6.2 Error Codes Display Message)
Manufacturer document
Frigidaire / Electrolux
July 2024 / PDF p.6-7 (4.1 display messages and note)
Printed once, in section 6.2 of manual A01704805/A (July 2024), which belongs to the knob-operated model.
Only the reset is documented. The manual lists no part and no cause for C0, and we do not guess at one.
The manual says it shows in zones 1 or 2 on the left, whichever zone has the error.
We would not. The cooktop is reporting an error and its knobs may not respond. Turn everything off until it is checked.
The other way round. With both conditions on the first two zones, the manual lets the error replace the heat warning.
Code / problem / part / repair
Frigidaire's knob-operated induction cooktop prints HE for Hot Element: the surface has not cooled enough to touch safely. It is a warning, not an error. Stay off the glass until the indicator light is out.
An uneven flame usually means clogged ports or a cap that is not seated. An orange flame can come from dust in the gas line, which clears in a few minutes, or from a wrong L.P. conversion. A flame set too high points to the knob, the cap or the L.P. kit.
Book a diagnostic for your model, done at your home.
Office addresses and the entry details to have ready.