Start from the symptom
Frigidaire dishwasher not drying dishes.
Wet dishes aren’t always a failure. Frigidaire’s drying article points first at what is wet, the cycle and drying option you chose, rinse aid, water temperature and the drain hose. Plastic and bowls with a concave bottom often stay damp.

Start with safe observations.
Turn the appliance off and unplug it before any owner check. Look out for standing water and sharp debris. Never touch a wet plug or wiring, take off service panels, or go past the owner steps in your manual.
- 1
Which items are wet
Plastic, wooden and concave items such as bowls may not dry completely. Tilt bowls at an angle so water runs off.
- 2
Which settings you used
Quick Wash and 30 minute cycles may not dry fully. Heat Dry with rinse aid adds heat to drying. Air Dry relies on air, can leave dishes damp and may show vapor at the vent. Sahara Dry and PowerPlus Dry add a fan on select models. The manual says that with no heat option lit, the heater is off in the drying phase.
- 3
Rinse aid
Rinse aid helps water sheet off dishes. Check the dispenser is filled, and on units that allow it, raise the rinse aid setting as the manual describes.
- 4
Water temperature
Frigidaire recommends a water heater set to at least 120°F. Running the kitchen tap hot before you start the dishwasher helps.
- 5
Drain hose
Check whether the drain hose has been moved or displaced. On a new install, look for the high hoop and the knockout plug as the installation instructions show.
Systems a technician may investigate.
These parts are linked to the problem. What you noticed does not prove any one of them has failed.
If the display adds a code.
This topic has no code tied to it.
No other researched code is tied to this topic. Check the exact message in your model manual rather than borrowing another code from the library.
See the research statusRead the related care guide.

Strange noise from the dishwasher? Start here.
Most dishwasher sounds are part of a normal cycle. Frigidaire's noise guide lists hissing from the water valve, humming from the wash and drain pumps, clunks from the detergent cup and ball valve, and whooshing spray arms. A knock or bang usually means something is hitting a spray arm.

Spotty glasses and damp dishes? Check the rinse aid first.
Fill the rinse aid dispenser to the indicated level without overfilling, raise the L0 to L6 setting one step if you see spots and poor drying, and keep the detergent dose matched to your water hardness.
When observation becomes a service request.
Leave internal testing to a technician.
Book a visit if dishes stay wet after a Heat Dry cycle with rinse aid and 120°F water, or if water stands in the tub after the cycle, which the manual calls not normal. If installed in the last 30 days, Frigidaire says to go back to the installer.
Arrange a diagnosticSources and model boundaries.
These documents back up the Frigidaire dishwasher not drying dishes advice. Use the manual that matches your model.
- Dishwasher - Not Drying (KB 1819543)
- Dishwasher Use & Care, A23587501B
Follow the instructions written for your own model. See how we research these pages.
Why are my plastic dishes still wet?
Plastic holds water and dries poorly, and Frigidaire says it’s normal for plastic and concave items to keep a little water. Towel-dry them if needed.
Does Air Dry mean the dishwasher is broken?
No. Air Dry uses no heat, so dishes may not be completely dry. Pick Heat Dry, High Temp or Sanitize Temp where your model has them.
Does rinse aid really matter for drying?
Yes. Frigidaire says rinse aid helps water sheet off dishes, and Heat Dry with rinse aid gives the better drying result.
Is standing water in the tub a drying problem?
No, it’s a draining problem. The manual says water left in the tub bottom after the cycle is not normal and sends you to its does-not-drain checks.
Code / problem / part / repair
From the code to what you do next.
Frigidaire dishwasher noises
Most dishwasher sounds are part of a normal cycle. Frigidaire’s noise guide lists hissing from the water valve, humming from the wash and drain pumps, and a clunk when the detergent cup opens. A knock or bang usually means something is hitting a spray arm.
Dishwasher heating element
The heating element warms the water and helps dry the load. Frigidaire’s manual lists it among the dishwasher’s parts and warns that it stays hot, so let it cool before cleaning the tub. i60 means a problem with water heating, and HO or Hd means Heat Delay or Heater On mode, a heating step rather than a problem.
Dishwasher repair
Book a diagnostic for your model, done at your home.
Find your metro
Office addresses and the entry details to have ready.
