Inside the appliance
Washer drain pump and filter. In plain English.
The drain pump pushes water out of the washer. On Frigidaire’s front-load washer it has a pump filter behind a small cleanout door, and a clogged filter is one cause of a washer that won’t drain. The manual says a humming or gurgling pump is normal. Pumping sounds that change to rattling may point to something in the pump.

Where it fits.
Washer drain pump and filter in the appliance
On the front-load model the pump filter is behind a pump cleanout door on the front. The pump itself is inside and isn’t reached.
The photo shows the kind of part. It is not a guide to the right replacement for your model.
What you notice when this part needs attention.
Trouble with the Washer drain pump and filter can show up as weaker performance or a code that keeps coming back. Only testing shows whether this part is the cause.

Frigidaire washer not spinning
On a top-load Frigidaire, the usual cause is an unbalanced load or a lid that isn’t closed. Frigidaire’s tub-not-spinning article says to power off, wait for the lid to unlock, rearrange the clothes and restart. After that it checks load size, shipping materials, level and hose connections.

Frigidaire washer not draining
On a top-load Frigidaire, check the drain hose and standpipe first, then detergent. E2 means the unit took over 10 minutes to drain. Frigidaire’s article asks if the washer has been moved, if the hose is kinked, and if the standpipe is the right height.
Owner care, within the model instructions.
Turn the appliance off and unplug it before any owner check. Look out for standing water and sharp debris. Never touch a wet plug or wiring, take off service panels, or go past the owner steps in your manual.
- 1
Check hose and standpipe
For a top-load washer, Frigidaire says to straighten a kinked hose, keep the standpipe at no more than 96 inches, and not seal the hose tight, because the standpipe needs air.
- 2
Clean the pump filter
Front-load washers have a pump filter cleanout door at the bottom front. With the washer off and cooled, drain it into a catch pan, then unscrew, rinse and reinsert the filter. Check the O-ring is in place.
- 3
Listen for hum or rattle
Frigidaire says humming and gurgling from the drain pump are normal. Rattling may mean coins or safety pins are in the tub or pump, so run an empty cycle to see if it continues.
- 4
Reduce the detergent
Frigidaire says too much detergent can stop a washer draining. Keep each compartment under its fill line.
Cleaning or replacement?
Leave internal testing to a technician.
Book a visit if the washer still won’t drain after the hose and pump filter are clear, or if rattling continues after you remove objects. Don’t drain a tub full of hot water; the manual warns of burns.
Arrange a diagnosticSources and model boundaries.
These documents back up the Washer drain pump and filter advice. Use the manual that matches your model.
- Front Load Washer Use & Care Guide, A33032801
- All about the Use & Care of your Washer, A29259301
- Laundry top loading washer is not draining (KB 1834688)
- Laundry Washers Noises Guide (KB 1820062)
Follow the instructions written for your own model. See how we research these pages.
Where is the pump filter on my washer?
On Frigidaire’s front-load washer, open the small pump cleanout door and lower the flap in front of the drain pump filter. Your guide shows the spot; the top-load manual reviewed here describes none.
How do I drain the washer by hand?
Frigidaire’s front-load guide says to put a catch pan under the pump filter and turn it 180 degrees counterclockwise, repeating until the drum is empty. Never do it if the water is hot.
Is a humming drain pump normal?
Yes. Frigidaire’s front-load manual says humming and gurgling while water is pumped out are normal and show the pump is working. A low hum from the drain pump is also listed in its noise guide.
Why is my washer rattling while it drains?
Coins and safety pins in the tub or pump can rattle. Frigidaire says to stop the washer and check the drum, then run it empty to see if the noise continues.
Code / problem / part / repair
From the code to what you do next.
Frigidaire washer not spinning
On a top-load Frigidaire, the usual cause is an unbalanced load or a lid that isn’t closed. Frigidaire’s tub-not-spinning article says to power off, wait for the lid to unlock, rearrange the clothes and restart. After that it checks load size, shipping materials, level and hose connections.
Washer repair
Book a diagnostic for your model, done at your home.
Find your metro
Office addresses and the entry details to have ready.

