Inside the appliance
Range oven temperature probe. In plain English.
On electric ranges Frigidaire prints F30 as Open Probe and F31 as Shorted Probe. The sources add nothing beyond those names. The home step is the power reset in the pages: disconnect for up to 30 seconds, then try again.

Where it fits.
Range oven temperature probe in the appliance
Inside the oven; the Frigidaire pages never say where the probe is.
The photo shows the kind of part. It is not a guide to the right replacement for your model.
What you notice when this part needs attention.
Trouble with the Range oven temperature probe can show up as weaker performance or a code that keeps coming back. Only testing shows whether this part is the cause.

Frigidaire oven too hot, too cool or baking unevenly
Frigidaire’s own fix order starts with preheating, then rack position and bakeware, and only then calibration. Let the empty oven fully preheat with the door shut, then check pans and racks. On electric ovens the article also names low supply voltage and a worn door gasket. If it’s a gas range, read the recall note first.

Frigidaire oven or range not heating
Before anything else on a gas range, check whether it is covered by the CPSC recall 26-333 for delayed bake burner ignition. If it isn’t, work through Frigidaire’s checks: clock set, the right function started, and for burners the caps, ports and power cord. An electric range that heats nowhere right after install may have a wiring or voltage issue.
Owner care, within the model instructions.
Turn the appliance off and unplug it before any owner check. Look out for standing water and sharp debris. Never touch a wet plug or wiring, take off service panels, or go past the owner steps in your manual.
- 1
Disconnect power
Unplug the range or flip the breaker off for up to 30 seconds.
- 2
Switch back on
Restore power and set the clock.
- 3
Test a bake
Try a short Bake. If the code returns, stop restarting it.
Cleaning or replacement?
Leave internal testing to a technician.
F30 or F31 returns after the reset.
The oven fails to hold its temperature.
The code appears on the first use after installation.
Arrange a diagnosticSources and model boundaries.
These documents back up the Range oven temperature probe advice. Use the manual that matches your model.
- Range Error Code F30 - Open Probe (KB 1846385)
- Range Error Code F31 - Shorted Probe (KB 1846386)
Follow the instructions written for your own model. See how we research these pages.
What does F30 mean?
Open Probe, with a power reset of up to 30 seconds as the home step.
What does F31 mean?
Shorted Probe, with the same reset.
Is the probe the meat probe?
The Frigidaire pages do not say which probe. We would not assume.
What if it was installed less than 30 days ago?
Frigidaire points the owner of a range under 30 days old to the installer.
Code / problem / part / repair
From the code to what you do next.
F30
F30 is the entry Frigidaire lists as “Open Probe” for range ovens. The sources give no cause or part beyond the name. Reset the power, set the clock and retry Bake or Broil, then arrange service if F30 repeats.
Frigidaire range will not turn on or does not operate
If the whole range is dead, the manual starts with the cord and the breaker: plug it in firmly, check the fuse or breaker box, and confirm a power outage is not the reason. If only the oven stays off, check the clock and the selected function. On gas models, check the gas regulator.
Range repair
Book a diagnostic for your model, done at your home.
Find your metro
Office addresses and the entry details to have ready.

