Inside the appliance
Range surface indicator lights. In plain English.
Frigidaire fits some ranges with a pair of lamps for the cooktop. One, labeled ELEMENT ON, shines while a burner or element is switched on. The other, HOT SURFACE, keeps shining after cooking until the glass has dropped to a moderate temperature. They report heat, not failures.

Where it fits.
Range surface indicator lights in the appliance
Usually on the display panel of the range.
The photo shows the kind of part. It is not a guide to the right replacement for your model.
What you notice when this part needs attention.
Trouble with the Range surface indicator lights can show up as weaker performance or a code that keeps coming back. Only testing shows whether this part is the cause.

Frigidaire range will not turn on or does not operate
If the whole range is dead, the manual starts with the cord and the breaker: plug it in firmly, check the fuse or breaker box, and confirm a power outage is not the reason. If only the oven stays off, check the clock and the selected function. On gas models, check the gas regulator.

Frigidaire range surface element not heating
On an electric range, an element that stays cold or heats unevenly is often down to the control knob, the cookware or the cooktop type. Check you used the right knob, use flat medium to heavy pans, and on a glass top cut the range's power briefly.
Owner care, within the model instructions.
Turn the appliance off and unplug it before any owner check. Look out for standing water and sharp debris. Never touch a wet plug or wiring, take off service panels, or go past the owner steps in your manual.
- 1
Glance after cooking
Use the ELEMENT ON light to make sure every surface control is off.
- 2
Wait for HOT SURFACE
The hot lamp holds on until the glass has cooled enough.
- 3
Read Before You Call
If a light behaves oddly, the Frigidaire article points to the manual's Before You Call section.
Cleaning or replacement?
Leave internal testing to a technician.
A light stays on with all controls off and a cold cooktop.
A light never comes on when an element heats.
The display is blank.
Arrange a diagnosticSources and model boundaries.
These documents back up the Range surface indicator lights advice. Use the manual that matches your model.
- Ranges - What do the indicator lights on my range mean? (KB 1847370)
- User Manual, Electric Range, A30923902
Follow the instructions written for your own model. See how we research these pages.
What does HOT SURFACE mean?
The cooking area was heated, and the lamp holds on until the glass is down to a moderate temperature.
What does ELEMENT ON mean?
At least one surface element is switched on.
Where are the lights?
Usually on the display panel.
Is the HOT SURFACE light a failure?
No. It only reminds you that the cooktop can still burn.
Code / problem / part / repair
From the code to what you do next.
Frigidaire range will not turn on or does not operate
If the whole range is dead, the manual starts with the cord and the breaker: plug it in firmly, check the fuse or breaker box, and confirm a power outage is not the reason. If only the oven stays off, check the clock and the selected function. On gas models, check the gas regulator.
Range repair
Book a diagnostic for your model, done at your home.
Find your metro
Office addresses and the entry details to have ready.

