Start from the symptom
Frigidaire refrigerator ice maker overflowing or ice jamming.
Frigidaire’s articles don’t describe an ice maker overflow as such, so we can’t name a cause from them. They do cover the nearby problems: ice jammed between the ice maker and the bin, a frozen auger, and frost or melt in the ice chute. Work through those, and turn the ice maker off if you need it to stop while you book.

Start with safe observations.
Turn the appliance off and unplug it before any owner check. Look out for standing water and sharp debris. Never touch a wet plug or wiring, take off service panels, or go past the owner steps in your manual.
- 1
Say which problem you have
Ice piling up in the bin, ice stuck in the chute and water on the floor are different problems. Frigidaire’s ice jam alert, DI SP, means a cube is stuck in the chute and an audible tone sounds.
- 2
Clear a jam
Take out the ice bin, thaw and empty it, then clean it, wipe it dry and replace it. Remove any cubes jammed between the ice maker and the back of the bin. Frigidaire says the dispenser should work again when new ice is made.
- 3
Don’t turn the auger
When removing or replacing the bin, avoid rotating the auger. If it does turn, Frigidaire says to realign it in 45-degree turns until the bin fits, or the door may not close properly.
- 4
Look at the chute
Open the door and look down the chute for frost, ice or a flap that isn’t closing. Ice that melts there can leak out. The frost article names a chute flap that sticks open as a source of frost.
- 5
Stop it while you wait
Pressing and holding the ice maker On/Off button on the control panel turns ice making off while you can still dispense ice and water. Leave the plastic signal arm alone; Frigidaire says not to use it to stop the ice maker by hand.
Systems a technician may investigate.
These parts are linked to the problem. What you noticed does not prove any one of them has failed.
If the display adds a code.
Keep the exact message.
We have not researched code meanings for this appliance yet. Use its manual and add a photo of the display to your request.
See the research statusRead the related care guide.

New fridge, no ice or water? Start here.
Air trapped in the new water line is the first thing Frigidaire names for uneven water or empty ice cycles on a just-installed unit. Prime and purge the line, give the ice maker up to 24 hours after the fridge has cooled, and check the water supply, the filter and the display lock.

Puddle under the fridge? Start here.
Frigidaire sorts refrigerator leaks by where the water is: outside the unit at the back connections and valve, inside the cabinet at the water filter, or at the dispenser chute and tip. A door left open can also ice up the evaporator and drip from the bottom.
When observation becomes a service request.
Leave internal testing to a technician.
Book a visit if ice or water keeps spilling after the bin is cleared and the chute is clean, or DI SP returns. Tell us what it does: ice in the bin, in the chute or water on the floor.
Arrange a diagnosticSources and model boundaries.
These documents back up the Frigidaire ice maker overflowing or ice jamming advice. Use the manual that matches your model.
- Refrigerators - No Ice (KB 1898308)
- Refrigerator Error Codes and Alarms Guide (KB 1847088)
- Refrigerator Error Code DI SP (or DISP) - Ice Jam
- Refrigerators / Freezer - Frost Build Up (KB 1918348)
- Refrigerator Use & Care Guide, A23655704
Follow the instructions written for your own model. See how we research these pages.
What does DI SP mean on a Frigidaire refrigerator?
Frigidaire lists DI SP as an ice jam: a cube is stuck in the chute and an alarm sounds. Look in the chute, clear it, then check the ice bin for ice frozen around the auger.
Why is ice stuck in my Frigidaire ice bin?
Frigidaire says ice can melt and refreeze around the auger after infrequent use, temperature changes or a power cut, or cubes can jam between the ice maker and the back of the bin.
How do I realign the ice bin auger?
If it was turned, Frigidaire says to turn it in 45-degree steps until the bin fits into place. A misaligned auger can stop ice dispensing and stop the door closing properly.
How do I switch the ice maker off?
Hold the ice maker On/Off button on the control panel. The manual says ice making stops but you can still dispense ice and water.
Does Frigidaire say what makes an ice maker overflow?
Not in the articles we can cite. They cover no ice, jams and frost. If the problem is something else, we’ll look at it during a visit.
Code / problem / part / repair
From the code to what you do next.
Frigidaire refrigerator leaking water
Frigidaire sorts refrigerator leaks by where the water shows up: outside the unit (back connections and the water valve), inside (the water filter), or at the dispenser (frost in the chute, or air in the line). A door left open can also ice up the evaporator and leak from the bottom. Find the spot first, and book if the source isn’t one of these.
Ice maker
The ice maker fills with water, freezes cubes and drops them into the bin. Frigidaire says a new unit needs 24 hours to settle before it makes ice, and that most problems come from the water supply, a locked display, a frozen auger or ice jammed between the maker and the bin.
Refrigerator repair
Book a diagnostic for your model, done at your home.
Find your metro
Office addresses and the entry details to have ready.
