Maintenance

Cleaning gas range grates, caps and ignition ports on a Frigidaire

To clean a Frigidaire gas cooktop, let it cool, wash the grates, caps and burner heads, clear the slots and ignition ports, dry everything completely and seat each head and cap properly before lighting a burner.

Cast iron cooktop grate resting on a towel beside a gas cooktop showing one burner head and its separate round cap.
Experienced techniciansWarranty on our workmanshipOEM parts available on orderUpfront pricing, agreed before work
On this page
Key points
  • Cast iron grates: dishwasher, a thin coat of cooking oil, then 10 minutes at 350°F. 1
  • Burner heads and caps: hot soapy water, a toothbrush, a wiped orifice, and fully dry before use. 4
  • Ports clog with food and cause uneven flames; clear them with the burner off and cool. 24
  • No oven cleaner, abrasive cleanser or steel wool around the burner head. 24
  • CPSC recall 26-333 concerns the oven bake burner, not the cooktop burners. 5

How do I clean the grates on a Frigidaire gas range?#

Let the cooktop cool, lift the grates off and wash them. Frigidaire's article puts both cast iron and porcelain-coated grates in the dishwasher; cast iron then gets a thin coat of cooking oil and 10 minutes in a 350°F oven. The range manual describes a plastic scrubbing pad instead. 14

The article and the manual describe different routes, and your own manual has the final say for your range.

Cast iron grates#

The Owner Center article gives three steps: wash the grates in the dishwasher, coat them with a thin layer of cooking oil, and bake them in the oven at 350°F for 10 minutes. 1

Porcelain-coated grates#

Put them in the dishwasher. After washing, coat any unfinished areas with a thin layer of cooking oil. 1

Cleaning them by hand#

The gas range manual doesn't mention the dishwasher. For the grates and the burner caps it says to use a non-abrasive plastic scrubbing pad with a mild abrasive cleanser, and to dry them thoroughly straight away. 4

Putting the grates back#

Set each grate flat-side down in the recess on the cooktop. They should rest flush against each other and against the sides of the recess. Don't line the area under the grates, or any part of the cooktop, with aluminum foil or any other lining. 4

How do I clean the burner heads and caps?#

With the burners off and cool, lift off each cap and head and wash them in hot soapy water. Soften burned-on spills first, scrub the head with a toothbrush, wipe the burner orifice with a cloth, and make sure everything is completely dry before you put it back. 4

The manual calls this "cleaning the sealed burners". It matters beyond looks: Frigidaire says that keeping the burner head ports and slots clean prevents improper ignition and an uneven flame. 4

  1. 1

    Turn the burners off and let them cool#

    The manual says not to clean before every surface burner is off and has cooled, to avoid burns. 4

  2. 2

    Remove the cap and the head#

    Lift off the burner cap, then the burner head. Wash both in hot soapy water and dry them thoroughly. 4

  3. 3

    Soften burned-on spills#

    For burned-on and dried spills, apply hot soapy water to the cap and head and give the soil time to soften. 4

  4. 4

    Brush the head#

    Use a toothbrush all over the burner head. A soft bristle brush also works for the slots and holes, according to the knowledge-base article. 24

  5. 5

    Wipe and dry#

    Wipe the cap and head with a soft, clean cloth, sponge or scratch-free pad. Wipe out the burner orifice with a cloth before the head goes back on. The whole burner assembly must be completely dry before use. 4

  6. 6

    Seat the head and the cap#

    The three mounting legs on the burner line up with the slots on the orifice holder. The head has a hole that fits over the ignitor, so it should fit snugly. A correctly placed cap does not move off the head. 4

If a burner doesn't light afterward, recheck how the head sits on the orifice holder and how the cap sits on the head. That is the manual's own first step. 4

What to avoid#

Don't use abrasive cleansers, oven cleaners or steel wool on the cooktop around the burner head. Frigidaire says they can damage the cooktop finish. The manual adds that you must not use spray oven cleaner on the cooktop. The article also cautions against brushes on the cooktop surface itself, so keep the brush on the burner head. 24

Never let spills, food, cleaning agents or anything else get into the gas orifice port opening, and never operate a burner without its cap. 4

How do I clean the ignition ports?#

Clear the ports with the burner off and cool. Frigidaire's ignition-port article suggests a toothpick, a paperclip or an ignition-port cleaning brush for blockage, while the range manual names a small-gauge wire or needle. Then wipe clean and seat the caps before using the cooktop. 24

Each surface burner has a ring of slots and small holes around its head. When they clog with food, the flame can come out uneven or only part way around the cap, and the burner may not light at all. 34

Two sources, two tools#

The knowledge-base article lists a toothpick, a paperclip or an ignition-port cleaning brush. The gas range manual's troubleshooting table says to use a small-gauge wire or needle, with the burner off and cool. 24

Both are thin tools, and the job is the same: clear food out of the slot or port. Keep debris and cleaning agents out of the gas orifice opening. 4

After cleaning#

If there's moisture left in the burner after you clean, the manual's tip is to lightly fan the flame and let the burner run until the flame is full. 4

The manual describes a good flame as clear, blue and hardly visible in a well-lit room, with steady, sharp cones. A yellow-orange flame means the burner should be adjusted or cleaned. 4

How often does the cooktop need cleaning?#

Wipe up spills when the surface is cool, and do the full burner-head clean when you see burned-on soil, an uneven flame or a burner that is slow to catch. The sources give no schedule for gas cooktops, only the instruction to clean routinely. 4

The manual says to clean the cooktop routinely: wipe it over with a damp cloth, then dry it to avoid scratches. 4

A short routine#

  • Let the cooktop cool, then wipe it with a damp cloth and dry it. 4
  • Blot up spills in the recessed areas with an absorbent cloth, rinse with a damp cloth and wipe dry. 4
  • Take off a cap and head when the flame looks uneven, and clean the slots and ports. 34
  • Seat every cap level before you light the burner. 34

When is it more than cleaning?#

If a burner still won't light after the knob, the caps and the ports check out, stop there and book a visit. Frigidaire's own checklist for burners that won't light is the knob set to Lite, caps in place and level, and ports not clogged. 3

On electric-ignition models, the manual also lists a power cord that isn't plugged in and a tripped circuit as reasons the burners don't ignite. Check those before you book. 4

Recall note for the oven#

This guide is about the cooktop. Separately, the U.S. Consumer Product Safety Commission announced recall 26-333 on March 19, 2026 for certain Frigidaire gas ranges, because the oven's bake burner can have delayed ignition. The CPSC says cooktop burners can continue to be used. Check your model and serial number against the notice. 5

You can book a visit or read about our cooktop service and oven service. The technician agrees the price with you before any work starts. The exact cost is confirmed after the on-site diagnostic. Repairs covered by Frigidaire's warranty go through Frigidaire itself. We give a warranty on our workmanship.

Sources#

  1. Ranges - How can I clean my gas range/cooktop grates?Frigidaire / Electrolux · Owner Center knowledge-base article (undated) · Whole article (grates)
  2. Gas Cooktop Ignition Port Cleaning GuideFrigidaire / Electrolux · Owner Center knowledge-base article (undated) · Whole article (cleaning instructions)
  3. What should I do if some or all of my burners are not lighting?Frigidaire / Electrolux · Owner Center knowledge-base article (undated) · Whole article (checks)
  4. User Manual, Gas Range, A30923903Frigidaire / Electrolux · Current edition (20 pages, no date printed) · PDF pp. 3, 7, 8, 14, 17
  5. Electrolux Group Recalls Frigidaire Gas Ranges Due to Burn Hazard (recall 26-333)U.S. Consumer Product Safety Commission · March 19, 2026 · Recall notice

Here to help

Good questions.
Clear answers.

Talk to our team
Can Frigidaire gas range grates go in the dishwasher?

Frigidaire's Owner Center article says yes for cast iron and porcelain-coated grates. Cast iron then gets a thin coat of cooking oil and 10 minutes at 350°F. The range manual describes hand cleaning. See sources 1 and 4.

What can I use to clear a clogged ignition port?

The knowledge-base article names a toothpick, a paperclip or an ignition-port cleaning brush. The range manual says a small-gauge wire or needle, with the burner off and cool. See sources 2 and 4.

Why is my burner flame yellow or uneven?

The manual says a good flame is clear and blue, and to adjust or clean the burner if it's yellow-orange. Clogged slots, ports or a cap that isn't level cause an uneven flame. See source 4, pages 8 and 17.

Is oven cleaner safe on the cooktop?

No. Frigidaire says not to use spray oven cleaner on the cooktop, and not to use abrasive cleansers, oven cleaners or steel wool around the burner head. See sources 2 and 4.

Is the gas range recall about the cooktop burners?

No. CPSC recall 26-333 is about delayed ignition of the oven's bake burner on certain models, and the CPSC says the cooktop burners can still be used. See source 5.

Let’s take care of it.

The range is the heart
of the kitchen. Let’s fix it.