Frigidaire dishwasher SD / Dishwasher

Frigidaire dishwasher
error SD

Frigidaire's two dishwasher code tables stop at the i-codes (i10 to iC0) and their E equivalents, and SD is in neither, so we assign no meaning. Press Cancel or cut the breaker for five minutes, check the filter and drain, and book a visit if SD stays.

No meaning given in the documents we checked

Last reviewed

SD
SDDishwasher
Manual evidence

What the manual says about Frigidaire dishwasher SD.

Manual evidence

Both published tables stop at i10 to iC0 and the matching E10 to EC0. The rinse-aid levels run L0 to L6. SD is in none of them. A footnote says Cancel, or a five-minute breaker-off wait, should clear an error.

Safe first steps.

  1. 1

    Cancel, or switch the breaker off

    Press Cancel. If SD stays, cut the breaker feeding the dishwasher for five minutes, the footnote's reset, then restore power and start a short cycle.

  2. 2

    Check the filter and the drain

    Pull the lower rack, rinse the filter, then look the drain hose over for kinks. Two of the explained codes concern slow draining, so this is the first place to look.

  3. 3

    Close the door properly

    Latch the door fully and make sure nothing blocks the rack. A door that does not seat can stop a cycle and flash messages.

Note these details before you book.

Open dishwasher with empty racks between walnut kitchen cabinets
  • Model and serial number
  • Full display text
  • When the message appears
  • Steps you have already taken

When to call.

SD returns after the reset, standing water remains after draining, or no cycle will start or finish.

Book a visit(844) 481-0454

The documents we checked.

Source 1

Dishwasher Use & Care Guide, A117867311

Frigidaire / Electrolux / September 2020 / PDF p.9 (error code table and footnote)

Source 2

User Manual, Dishwasher, 117825980A

Frigidaire / Electrolux / Current edition (28 pages, no date printed) / PDF p.10 (error code table and footnote)

Source 3

Dishwasher Error Codes and Alarms Guide (KB 1829620)

Frigidaire / Owner Center knowledge base / Owner Center article, cached 10.11.2026 (no edition date printed) / Article text

Here to help

Good questions.
Clear answers.

Talk to our team
Does Frigidaire list SD for dishwashers?

No. Both code tables and the rinse-aid levels were checked, and SD is not among them.

Is SD the same as an i-code?

We can't tie it to one. Frigidaire explains i10, i20, i30, i40, i50, i60 and iC0 only, and SD is a different string.

Will resetting the breaker clear SD?

It can. The footnote suggests leaving the breaker off for five minutes. If SD returns after that, the cause is still there.

What do I tell the technician about SD?

The model from the label, the display as shown, and whether the dishwasher still fills, washes and drains when SD shows.

Let’s take care of it.

The range is the heart
of the kitchen. Let’s fix it.