Manual evidence
Both published tables stop at i10 to iC0 and the matching E10 to EC0. The rinse-aid levels run L0 to L6. Lo is in none of them. A footnote says Cancel, or a five-minute breaker-off wait, should clear an error.
Frigidaire dishwasher Lo / Dishwasher
Frigidaire's two dishwasher code tables stop at the i-codes (i10 to iC0) and their E equivalents, and Lo is in neither, so we assign no meaning. Press Cancel or cut the breaker for five minutes, check the filter and drain, and book a visit if Lo stays.
Press Cancel. If Lo stays, cut the breaker feeding the dishwasher for five minutes, the footnote's reset, then restore power and start a short cycle.
Pull the lower rack, rinse the filter, then look the drain hose over for kinks. Two of the explained codes concern slow draining, so this is the first place to look.
Latch the door fully and make sure nothing blocks the rack. A door that does not seat can stop a cycle and flash messages.

Lo returns after the reset, standing water remains after draining, or no cycle will start or finish.
Source 1
Frigidaire / Electrolux / September 2020 / PDF p.9 (error code table and footnote)
Source 2
Frigidaire / Electrolux / Current edition (28 pages, no date printed) / PDF p.10 (error code table and footnote)
Source 3
Frigidaire / Owner Center knowledge base / Owner Center article, cached 10.11.2026 (no edition date printed) / Article text
No. Both code tables and the rinse-aid levels were checked, and Lo is not among them.
We can't tie it to one. Frigidaire explains i10, i20, i30, i40, i50, i60 and iC0 only, and Lo is a different string.
It can. The footnote suggests leaving the breaker off for five minutes. If Lo returns after that, the cause is still there.
The model from the label, the display as shown, and whether the dishwasher still fills, washes and drains when Lo shows.