Start from the symptom
Frigidaire dryer runs but won’t heat.
If the drum turns but the air stays cold, Frigidaire’s first suspects are the Air Fluff setting and, on an electric dryer, one of its two house fuses or breakers. On a gas dryer, check the gas supply valve and the tank.

Start with safe observations.
Turn the appliance off and unplug it before any owner check. Look out for standing water and sharp debris. Never touch a wet plug or wiring, take off service panels, or go past the owner steps in your manual.
- 1
Check the cycle
Air Fluff, or an air-only temperature, tumbles without heat. Pick a heated cycle.
- 2
Electric: two house breakers
An electric dryer’s circuit has two. If one has tripped or blown, the drum may still turn but the heater won’t work. Reset the breaker or replace the fuse.
- 3
Electric: the outlet
Have a qualified electrician verify the supply is 240 volts at the outlet.
- 4
Gas: supply valve
Make sure the gas supply valve is open. The installation instructions show how.
- 5
Gas: tank or utility
For LP gas, an empty tank needs refilling or replacing. If natural gas was interrupted, the utility handles that, and the dryer should heat when service is restored.
- 6
Gas: air around the dryer
The burner needs space for air. Don’t stack laundry or rugs against the front or back of the dryer.
- 7
Check for E5
E5 means the temperature sensor failed. Frigidaire’s manual says to call service.
Systems a technician may investigate.
These parts are linked to the problem. What you noticed does not prove any one of them has failed.
If the display adds a code.
Keep the exact message.
We have not researched code meanings for this appliance yet. Use its manual and add a photo of the display to your request.
See the research statusWhen observation becomes a service request.
Leave internal testing to a technician.
Book a visit if the cycle, breakers, valve and tank are fine and the dryer still doesn’t heat. For a gas smell, leave the home and call your gas utility first; we can look at the dryer afterward. Don’t open wiring or gas lines yourself.
Arrange a diagnosticSources and model boundaries.
These documents back up the Frigidaire dryer runs but won’t heat advice. Use the manual that matches your model.
- My dryer is running, but does not seem to be heating (KB 1853007)
- All about the Use & Care of your Dryer, A29259201
Follow the instructions written for your own model. See how we research these pages.
Why does my dryer spin but not heat?
On an electric Frigidaire, one of the two house breakers or fuses may be tripped, so the drum turns without the heater. Reset it or replace the fuse, and book a visit if it recurs.
Could the setting be the problem?
Yes. Air Fluff and air-only temperatures run without heat. Pick a normal heated cycle.
What should I check on a gas dryer?
The gas supply valve, the LP tank, and that nothing is stacked against the dryer. A natural gas interruption is for your gas company.
What does E5 mean?
The temperature sensor failed, and the manual says to call service. Book a visit.
Code / problem / part / repair
From the code to what you do next.
Frigidaire dryer takes too long to dry
Start with the lint screen and the cycle setting, then the load, humidity and the venting. Frigidaire’s article puts lint screen cleaning after every use first. A clogged duct or hood is the other big one, and a 208-volt circuit lengthens drying by about 20 percent.
Dryer thermal limiter
The thermal limiter is a safety switch in an electric Frigidaire dryer. The manual says it turns off the motor in the unlikely event of an overheated situation, and that a service technician must replace it after the cause is corrected.
Dryer repair
Book a diagnostic for your model, done at your home.
Find your metro
Office addresses and the entry details to have ready.
