Inside the appliance
Dryer thermal limiter. In plain English.
The thermal limiter is a safety switch in an electric Frigidaire dryer. The manual says it turns off the motor in the unlikely event of an overheated situation, and that a service technician must replace it after the cause is corrected.

Where it fits.
Dryer thermal limiter in the appliance
Inside the electric dryer cabinet. The manual does not say where; a technician replaces it.
The photo shows the kind of part. It is not a guide to the right replacement for your model.
What you notice when this part needs attention.
Trouble with the Dryer thermal limiter can show up as weaker performance or a code that keeps coming back. Only testing shows whether this part is the cause.

Frigidaire dryer takes too long to dry
Start with the lint screen and the cycle setting, then the load, humidity and the venting. Frigidaire’s article puts lint screen cleaning after every use first. A clogged duct or hood is the other big one, and a 208-volt circuit lengthens drying by about 20 percent.

Frigidaire dryer won’t start or stops
Frigidaire’s start checks are the Start button held for two seconds, the cycle knob position, the door, the plug and the breaker. If it starts then stops, the motor may have overheated, or on an electric dryer the thermal limiter may have tripped.
Owner care, within the model instructions.
Turn the appliance off and unplug it before any owner check. Look out for standing water and sharp debris. Never touch a wet plug or wiring, take off service panels, or go past the owner steps in your manual.
- 1
Unplug the dryer
Unplug the dryer before you inspect it if it halted part-way through a cycle and will not restart.
- 2
Clear the lint and vent
The manual asks you to keep the lint screen, housing and exhaust duct clean, and to clear the outside exhaust hood of buildup.
- 3
Check for an obstruction
The troubleshooting table says a clogged outside hood or duct needs clearing.
- 4
Do not bypass it
The switch is a safety part. A technician replaces it once the cause of the overheating is fixed.
Cleaning or replacement?
Leave internal testing to a technician.
The dryer is dead after the vent is clear.
The dryer overheated and shut off more than once.
There is a burning smell.
Arrange a diagnosticSources and model boundaries.
These documents back up the Dryer thermal limiter advice. Use the manual that matches your model.
- All about the Use & Care of your Dryer, A29259201
Follow the instructions written for your own model. See how we research these pages.
What does the thermal limiter do?
It switches the motor off if the dryer overheats. The manual lists it for electric dryers only.
Can I replace it myself?
A service technician has to replace it once the cause is corrected, the manual says.
What usually overheats a dryer?
The manual points to lint and a clogged exhaust hood or duct as things to clear.
Is the thermistor the same part?
No. The manual names a separate temperature-regulating thermistor on the blower housing.
Code / problem / part / repair
From the code to what you do next.
Frigidaire dryer takes too long to dry
Start with the lint screen and the cycle setting, then the load, humidity and the venting. Frigidaire’s article puts lint screen cleaning after every use first. A clogged duct or hood is the other big one, and a 208-volt circuit lengthens drying by about 20 percent.
Dryer repair
Book a diagnostic for your model, done at your home.
Find your metro
Office addresses and the entry details to have ready.

