Inside the appliance
Dryer lint filter. In plain English.
The lint filter catches lint so air can flow through the dryer. Frigidaire says to clean it before or after every load, since a clogged filter makes drying slower and lint is a fire risk. Wash it in warm soapy water now and then to clear the waxy film that fabric softener sheets leave behind.

Where it fits.
Dryer lint filter in the appliance
It is in the dryer at the bottom of the door opening. Frigidaire says to pull it straight up and out.
The photo shows the kind of part. It is not a guide to the right replacement for your model.
What you notice when this part needs attention.
Trouble with the Dryer lint filter can show up as weaker performance or a code that keeps coming back. Only testing shows whether this part is the cause.

Frigidaire dryer takes too long to dry
Start with the lint screen and the cycle setting, then the load, humidity and the venting. Frigidaire’s article puts lint screen cleaning after every use first. A clogged duct or hood is the other big one, and a 208-volt circuit lengthens drying by about 20 percent.

Frigidaire dryer won’t start or stops
Frigidaire’s start checks are the Start button held for two seconds, the cycle knob position, the door, the plug and the breaker. If it starts then stops, the motor may have overheated, or on an electric dryer the thermal limiter may have tripped.
Owner care, within the model instructions.
Turn the appliance off and unplug it before any owner check. Look out for standing water and sharp debris. Never touch a wet plug or wiring, take off service panels, or go past the owner steps in your manual.
- 1
Empty it every load
Pull the filter straight up from the bottom of the door opening, wipe off the lint and slide it back in. Frigidaire says to do this before or after each load.
- 2
Wash off the film
A waxy build-up from dryer sheets can coat the filter and the moisture sensing bars. Wash both in warm soapy water, dry the filter thoroughly and replace it. Rubbing alcohol works on the bars.
- 3
Never run it without the filter
Frigidaire says not to operate the dryer without the lint filter in place, or with it blocked or damaged. Lint is combustible.
- 4
Check the load and the heat setting
If the filter is clean and drying is still slow, Frigidaire next checks load size, cycle and heat settings, humidity and venting.
Cleaning or replacement?
Leave internal testing to a technician.
Book a visit when the filter is clean and drying still takes too long, or if the dryer runs hot, smells like it is burning or stops mid-cycle. Don’t keep running a dryer that feels overheated.
Arrange a diagnosticSources and model boundaries.
These documents back up the Dryer lint filter advice. Use the manual that matches your model.
- Dryers - How often do I need to clean my dryer or the lint screen/filter (KB 1847456)
- Dryer - Not Drying and Extended Drying Time (KB 1853008)
- All about the Use & Care of your Dryer, A29259201
Follow the instructions written for your own model. See how we research these pages.
How often does the lint filter need cleaning?
Frigidaire says to clean the lint screen or filter before or after every load. Heavy lint blocks airflow and slows drying, and the dryer manual calls lint build-up a fire risk.
Why does my lint filter look coated?
Fabric softener sheets can leave a waxy film on the filter and the moisture sensing bars. Frigidaire says to wash them in warm soapy water, dry the filter fully and replace it.
Can I run the dryer without the filter?
No. Frigidaire says never to operate the dryer without the lint filter in place. Lint can reach the vent and the dryer interior, where it builds up and can ignite.
My filter is clean but clothes are still damp. Why?
Frigidaire’s next checks: load size, heat and cycle choice, humidity, the moisture sensor bars, the exhaust duct and hood, and 240-volt power on an electric dryer.
Code / problem / part / repair
From the code to what you do next.
Frigidaire dryer takes too long to dry
Start with the lint screen and the cycle setting, then the load, humidity and the venting. Frigidaire’s article puts lint screen cleaning after every use first. A clogged duct or hood is the other big one, and a 208-volt circuit lengthens drying by about 20 percent.
Dryer exhaust duct and vent hood
The exhaust duct and vent hood carry hot, damp air and lint out of the house. Frigidaire says to inspect and clean the outdoor exhaust about every 18 months, because a clogged duct slows drying. A gas dryer must never run without a duct that vents outdoors.
Dryer repair
Book a diagnostic for your model, done at your home.
Find your metro
Office addresses and the entry details to have ready.

