Manual evidence
The top-load guide A29259301 prints E1 to E5, E7, F2, F5, F8, Fd, C9 and CL. The front-load guide A33032801 prints AL 10, AL 20, AL 40, AL 91, AL F0 and AL H0. E52 appears in neither.
Frigidaire washer E52 / Washer
Frigidaire's current washer guides do not print E52. The top-load table covers E1 to E5, E7, F2, F5, F8, Fd, C9 and CL, and the front-load guide uses AL alarms. Reset the washer, check hoses and taps, and book a visit if E52 keeps coming back.
Stop the cycle with Cancel, or on a front-load turn the knob to its 12 o'clock reset position. Cutting power briefly also works. Then start a short cycle and watch for E52.
Open both taps all the way, straighten any kinked inlet hose and see that the drain hose has no pinch or kink. The guide starts its fill problems with these same steps.
Push down on each top corner. A washer that rocks can trip balance messages, and the guide asks you to relevel it before anything else.
If water shows around the washer, close both taps and unplug it before you do anything else.

E52 returns after the reset, the washer stalls mid-cycle without filling, emptying or spinning, or water shows around the cabinet.
Source 1
Frigidaire / Electrolux / July 2026 / PDF p.30 (Alarm codes)
Source 2
Frigidaire / Electrolux (retailer-hosted copy of the official document) / August 2024 / PDF p.18 (Error codes)
No. The guides we hold list other codes and none lists E52, so we can't name a cause for it.
It may be. Older front-loaders showed E-codes while current ones show AL alarms, but the table that explained them is not among the guides we hold.
Try one reset and a short cycle. If the washer fills, drains and spins normally, carry on and watch it. If E52 comes back or the cycle stops, book a visit.
The model from the label, precisely what the display reads, and the step of the cycle when E52 appeared.