Manual evidence
The dryer guide A29259201 has a short error table: C9, E4 and E5, with a failed control board, a failed humidity sensor and a failed temperature sensor as the possible causes. EAF is not in it.
Frigidaire dryer EAF / Dryer
Frigidaire's dryer guide prints three codes, C9, E4 and E5, and nothing for EAF, leaving us with no meaning to report. Clear the lint screen, look at the vent and the plug, and book a visit if EAF returns or the drum quits heating or drying.
Manual evidence
The dryer guide A29259201 has a short error table: C9, E4 and E5, with a failed control board, a failed humidity sensor and a failed temperature sensor as the possible causes. EAF is not in it.
End the cycle, leave the door shut for a couple of minutes, then restart a short load to see if EAF comes back.
Slide out the lint screen, wipe the lint off and put it back firmly. Frigidaire lists a clogged screen among the usual causes of long drying times.
Make sure the vent hose is not crushed behind the dryer and the plug sits fully in the outlet. Do not reach behind a hot dryer; wait until it has cooled.

EAF reappears following a restart, the dryer stops heating or drying, or a burning smell appears. Stop the dryer if you smell burning.
Source 1
Frigidaire / Electrolux (retailer-hosted copy of the official document) / August 2024 / PDF pp.14-15 (Avoid Service Checklist, Error Codes)
Frigidaire doesn't say. The guide we hold prints C9, E4 and E5 only, so any meaning for EAF would be a guess.
The guide ties its three printed codes to a control board, a humidity sensor and a temperature sensor, but it does not tie EAF to any of them.
After one restart, a short test load is reasonable if it tumbles and heats. Stop it at once if it smells hot or burning, and book a visit.
The model label, the display as shown and whether the dryer still tumbles and heats when EAF shows.